|
Name
|
Description
|
|
Corrections
|
Provides access to calibration and user corrections.
|
|
CurrentTemp
|
Return current sensor internal temperature in degrees C
|
|
Display
|
The Display interface provides access to vertical/horizontal scaling and offset properties.
|
|
Enabled
|
Set or return the measurement state of the selected channel. When the value is true, the channel performs measurements; when the value is false, the channel is disabled and no measurements are performed.
|
|
FirmwareVersion
|
Returns the firmware version of the power meter associated with this channel.
|
|
FPGAVersion
|
Returns the FPGA version for the power meter associated with this channel.
|
|
HardwareStatus
|
The HardwareStatus interface provides access to diagnostic, measurement, and acquistion status information.
|
|
MarkerMeasurements
|
Provides access to marker measurements.
|
|
Measurements
|
The Measurements interface provides access to CW, waveform, and automatic measurements.
|
|
Model
|
Model number of the meter connected to the specified channel.
|
|
PulseDefinitions
|
The PulseDefinitions interface contains properties for adjusting how automatic pulse measurements are calculated. Measurements such as rise time, fall time, and pulse width are affected by these adjustments.
|
|
RawIO
|
The RawIO interface provides acces to methods for sending and receiving data directly from USB.
|
|
Sense
|
The purpose of the Sense interface is to configure device specific settings used to make measurements, generally parameters related to the RF power sensor and signal processing. These properties and methods are used to configure the power meter for acquiring data. Sense enables you to change measurement parameters such as filtering or averaging, sensor bandwidth, operating frequency and calfactors, and measurement gain or offset.
|
|
SensorInfo
|
The SensorInfo interface provides data about the sensor.
|
|
SerialNumber
|
Serial number of the sensor.
|
|
StatisticalMode
|
Provides access to statistical mode measurements and settings.
|
|
TriggerAdjust
|
Provides trigger skew adjustments. These adjustments can be stored in the USB power meter by calling the SaveUserCal method.
|
|
Units
|
Set or return units for the selected channel. Voltage is calculated with reference to the sensor input impedance. Note that for ratiometric results, logarithmic units will always return dBr (dB relative) while linear units return percent.
|
